My current group plus new cage setup

Desdemona

New Member
Messages
653
Location
Bay Area, CA
A bit of a photo dump here... First Volta, a Tremper Reverse Stripe (though the whiteish stripe doesn't always show in photos).

IMG_2943.jpg


IMG_2947.jpg


She isn't quite so "whited" out by light in this one:

IMG_2946.jpg


Darwin my first, a petstore buy but I think she's a Murphy Patternless from pictures that I have seen of them. She stared out really grey but after a few sheds now looks more yellowish. She is in the new tank I set up for her and Curie.. with a divider in the middle which is only held stable due ot the slate tiles. I am keeping a careful eye on it to make sure it remains stable.

IMG_2962.jpg


IMG_2961.jpg


And Curie in the new tank:

IMG_2975.jpg


IMG_2963.jpg


I couldn't get a good picture of the whole thing since I'm short and its on top of my Dragon cage (high) but I did get this where you can see it's a modified fishtank divider:

IMG_2976.jpg


IMG_2977.jpg


I will say that the slate tile does look pretty nice, though I will need to get some pieces shaved off since I have a slight overlap on one side.
 

Desdemona

New Member
Messages
653
Location
Bay Area, CA
Thanks for the comments. I did have to modify that liner, I could put a post in the DIY section if you think it would be helpful, but the liner was not that stable until I combined pieces from two (which I needed to buy two in order to make a complete wall to the top) and held them in place with the tile. However, since it is doubled up for a section it is a little stronger than a single fish tank divider would be.

Hopefully on Thurs I'll be able to post some more pictures with my two new TUG Snows. I'm excited with the anticipation of two new and gorgeous geckos!
 

Visit our friends

Top