My multilevel cage project with pics

[robinson]

Ok so for the last few months i have been working on this fairly massive project (for me it is anyway). So i decided to have 3 seperate levels all completely divided to accomodate my fat tail gecko, and two male bearded dragons. Each beardy has a UVB buld and heat source, the fatty has a heat source. The whole setup is 6 feet tall, 4 feet wide and 2 feet deep, it fits convieniently into a cut out that exists in my bedroom lol. I have the fatty in the middle cage, everything was set up just fine and everthing was going great but after a checking out some of the great cage set ups on here i decided to improve the fat tails space with some creative foam work. so here are some pics from before during and after the building process of the foam work (the actual structure was done a while ago and i dont have pics of its building process). Hope everyone loves it,throw me some suggestions if u have any thanks.

sorry the pics aren't great i only have a camera phone lol

 

[Neill]

That looks awesome!

 

[ang3l3s]

looks nice, did u use grout????

 

[robinson]

i used joint compound on top of the foam for some texture and to fill it in a little better, then i used the same rustoleum textured spray paint that wreptile used on his "gecko mountain V1" and covered the whole thing in a spray on clear coat and let the whole thing sit in my garage for over a week to let it air out before putting the whole thing into the set up.

 

[Wreptile]

i used joint compound on top of the foam for some texture and to fill it in a little better, then i used the same rustoleum textured spray paint that wreptile used on his "gecko mountain V1" and covered the whole thing in a spray on clear coat and let the whole thing sit in my garage for over a week to let it air out before putting the whole thing into the set up.

Thanks for mentioning my project. That made me smile, knowing someone likes my ideas.